Mazda CX-7 2007 Workshop Manual page 1256

STEP
3 INSPECT SAS CONTROL MODULE
Warning
• Handling the air bag system
components improperly can
accidentally deploy the air bag
modules and pre-tensioner seat belts,
which may seriously injure you. Read
the air baga system service warnings
and cautions before handling the air
bag system components.
(See 08-10-3 AIR BAG SYSTEM
SERVICE WARNINGS.)
(See 08-10-5 AIR BAG SYSTEM
SERVICE CAUTIONS.)
• Turn the ignition switch to LOCK position.
• Disconnect the negative battery cable and
wait for 1 min or more.
• Remove the column cover. (See 09-17-8
COLUMN COVER REMOVAL/
INSTALLATION.)
• Disconnect the clock spring connector.
• Remove the glove compartment. (See 09-17-
8 GLOVE COMPARTMENT REMOVAL/
INSTALLATION.)
• Disconnect the passenger-side air bag
module connector.
• Disconnect the driver and passenger-side
front seat connectors.
• Remove the C-pillar trim. (See 09-17-17 C-
PILLAR TRIM REMOVAL/INSTALLATION.)
• Remove the D-pillar trim. (See 09-17-18 D-
PILLAR TRIM REMOVAL/INSTALLATION.)
• Disconnect the driver and passenger-side
curtain air bag module connectors.
• Remove the B-pillar lower trim. (See 09-17-
16 B-PILLAR LOWER TRIM REMOVAL/
INSTALLATION.)
• Disconnect the driver- and passenger-side
pre-tensioner seat belt connectors.
• Connect the negative battery cable.
• Turn the ignition switch to ON position.
• Does the air bag system warning light
illuminate?
4 INSPECT DTCS IN INSTRUMENT CLUSTER
• Inspect the DTC for the instrument cluster
on-board diagnostic system.
• Have DTCs been recorded in memory?
08-03–2
SYMPTOM TROUBLESHOOTING
INSPECTION
Yes Replace the SAS control module, then go to Step 5.
(See 08-10-10 SAS CONTROL MODULE REMOVAL/
INSTALLATION.)
No Go to the next step.
Yes Perform the applicable DTC inspection, then go to the next
step.
(See 09-02E-1 DTC TABLE[INSTRUMENT CLUSTER].)
No Inspect the instrument cluster warning lights using check
code, then go to the next step.
(See 09-22-5 INSTRUMENT CLUSTER INPUT/OUTPUT
CHECK MODE.)
ACTION