Mazda CX-7 2007 Workshop Manual page 1051

AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
4. Tighten the bolts in the order shown in the figure.
Tightening torque
8— 12 N·m {82— 122 kgf·cm, 72— 105 in·lbf}
5. Install the connector of the VSS and input/turbine
speed sensor to the solenoid clamp.
VSS CONNECTOR
Caution
• If the control valve body cover is installed with the wiring harnesses overlapped, the wiring
harnesses may be pinched between the cover and valve body causing the wiring harnesses to be
damaged. Therefore, verify that the wiring harnesses are not overlapped when installing the
control valve body cover.
6. Apply ATF to a new O-ring and install it on the TFT sensor.
1
3
7
INPUT/TURBINE SPEED SENSOR
CONNECTOR
NO GOOD
4
2
8
acxuuw00000599
acxuuw00000592
GOOD
acxuuw00000600
05-17–43
05-17