Mazda CX-7 2007 Workshop Manual page 695

03-10 GENERAL PROCEDURES
GENERAL PROCEDURES
(FRONT AND REAR AXLES) . . . . . . . 03-10–1
Wheel and Tire Installation . . . . . . . . . 03-10–1
End of Toc
GENERAL PROCEDURES (FRONT AND REAR AXLES) WM: DRIVELINE/AXLE
Wheel and Tire Installation
1. When installing the wheels and tires, tighten the
wheel nuts in a criss-cross pattern to the following
tightening torque.
Tightening torque
88.2— 117.6 N·m {9.00— 11.99 kgf·m,
65.06— 86.73 ft·lbf}
Suspension Links Removal/Installation
1. For the joint sections with rubber bushings, raise the vehicle using a lift, and then temporarily tighten the
installation bolts and nuts. Lower the vehicle to the ground and tighten them completely with the specified
torque.
Connector Disconnection
1. Disconnect the negative battery cable before performing any work that requires handling of connectors. (See
01-17-2 BATTERY REMOVAL/INSTALLATION[L3 WITH TC].)
Electronic AWD Control System Parts
1. After servicing the electronic AWD control system parts, verify that no DTC has been stored. Clear any DTCs
remaining in the memory.
End Of Sie
GENERAL PROCEDURES
Suspension Links
Removal/Installation . . . . . . . . . . . . . . 03-10–1
Connector Disconnection . . . . . . . . . . . 03-10–1
Electronic AWD Control System
Parts. . . . . . . . . . . . . . . . . . . . . . . . . . 03-10–1
id031000800100
1
4 3
2 5
acxuuw00000002
03-10–1
03-10