Mazda CX-7 2007 Workshop Manual page 1279

Passenger-side Air Bag Module
Warning
• The passenger-side air bag module is a dual inflator type. If one inflator is forced to operate
(deploy), the other may operate (deploy) accidentally. To prevent injury while disposing of the air
bag module, make sure to operate (deploy) both passenger-side air bag module inflators
simultaneously, following the procedure below.
Note
• The SSTs, two types of adapter harnesses (for inflators No.1 and No.2) and two deployment tools are to
be used to operate (deploy) the passenger-side air bag module.
1. Remove the glove compartment. (See 09-17-8 GLOVE COMPARTMENT REMOVAL/INSTALLATION.)
2. Disconnect the passenger-side air bag module connector.
3. Connect the SSTs (Adapter harness) to the
passenger-side air bag module as shown in the
figure.
4. Connect the SSTs (Deployment tool) to the SSTs (Adapter harness).
49 H066 002
5. Connect both SSTs (Deployment tool) to the battery. Connect the power supply red clip to the positive battery
terminal, and the black clip to the negative battery terminal.
6. Verify that the red lamp on both SSTs (Deployment tool) is illuminated.
7. Verify that all persons are standing at least 6 m {20 ft} away from the vehicle.
8. Press the activation switch on the SST
(Deployment tool) connected with 49 L066 002
(a yellow connector) of the SST (Adapter
harness), and after 3 s, press the activation
switch on the other SST (Deployment tool) to
operate (deploy) the air bag module (both
inflators).
Warning
• Verify that air bag module operation
(explosive) sound occurs twice. If no
operation (explosive) sound was heard or
a single operation (explosive) sound was
heard, both inflators would not have
operated (deployed) properly. This may cause serious injury if the air bag module operates
(deploy) unexpectedly. If the two operation (explosive) sounds are not heard, perform Step 8 again.
If a total of two operation (explosive) sounds cannot be verified even though Step 8 is performed
again, leave the air bag module alone for 30 min or more before approaching it again.
• The air bag module is very hot immediately after it is operated (deployed). You can be burned. Do
not touch the air bag module for at least 15 min after deployment.
9. Disconnect the SSTs (Deployment tool) form the SSTs (Adapter harness).
AIR BAG SYSTEM
PASSENGER-SIDE
AIR BAG MODULE
CONNECTOR
49 G066 003
49 H066 002
49 H066 002
PASSENGER-SIDE
AIR BAG MODULE
CONNECTOR
49 G066 003
49 L066 002
acxuuw00001708
49 L066 002
acxuuw00001266
ACTIVATION
SWITCH
acxuuw00001267
08-10–19
08-10