Mazda CX-7 2007 Workshop Manual page 1073

AUTOMATIC TRANSAXLE SHIFT MECHANISM
3. Push the a 1.5mm {0.059 in} round bar or similar
into hole A by fully pushing the slider pin in.
4. Fully pull the end of the interlock cable.
5. Push the a 1.5mm {0.059 in} round bar or similar
into hole B and hole C of the lock unit until it
passes through.
6. Disconnect the brake switch connector.
7. Remove the brake switch. (See 04-11-6 BRAKE
PEDAL REMOVAL/INSTALLATION.)
8. Install a new brake switch. (See 04-11-6 BRAKE
PEDAL REMOVAL/INSTALLATION.)
Caution
• Do not connect the brake switch
connector until the interlock cable is
installed.
9. With the slider pin pressed, slide the lock unit to
fix the lock unit hook into the bracket hole
securely as shown in the figure.
Caution
• Allowing the interlock cable to be bent or
twisted during installation can affect the
lock unit operation.
10. Rotate the slider pin to release the lock and verify
that it slides freely.
11. Pull the slider pin outward until it contacts the
brake pedal stopper rubber and rotate the slider
pin to lock.
12. Verify that the selector lever in the P position.
LOCK UNIT
C
B
A
SLIDER PIN
LOCK UNIT
C
A B
SLIDER PIN
BRACKET
LOCK UNIT
UNLOCK
LOCK
MARKING
SLIDER PIN
INTERLOCK
CABLE
BRAKE SWITCH
acxuuw00000425
INTERLOCK CABLE
acxuuw00000426
INTERLOCK
CABLE
BRAKE SWITCH
acxuuw00000425
SLIDER PIN
acxuuw00000427
acxuuw00000428
05-18–11
05-18