Mazda CX-7 2007 Workshop Manual page 1277

3A 3B
A/B A/B A/B
No.1 No.1 No.2
+ - +
1C 1D
1D 1C 1B 1A
3B 3A
End Of Sie
AIR BAG MODULE AND PRE-TENSIONER SEAT BELT DEPLOYMENT PROCEDURES
WM: AIR BAG MODULES
Warning
• A live (undeployed) air bag module or pre-tensioner seat belt may accidentally operate (deploy)
when it is disposed of and cause serious injury. Do not dispose of a live (undeployed) air bag
module and pre-tensioner seat belt. If the SSTs (Deployment tool and Adapter harness) are not
available, consult the nearest Mazda representative for assistance.
Caution
• Deploying the air bag modules and pre-tensioner seat belts inside the vehicle may cause damage
to the vehicle interior. When the vehicle is not to be scrapped, always deploy the air bag modules
and pre-tensioner seat belts outside the vehicle.
• If the vehicle is to be scrapped, or when disposing of any air bag modules or pre-tensioner seat belts, operate
(deploy) them inside the vehicle by following the deployment procedure below and using the SST (Deployment
tool).
• When disposing of an operated (deployed) air bag module and pre-tensioner seat belt, refer to "AIR BAG
MODULE AND PRE-TENSIONER SEAT BELT DISPOSAL PROCEDURES".
Deployment Procedure for Inside of Vehicle
1. Inspect the SST (Deployment tool). (See 08-10-31 INSPECTION OF SST (DEPLOYMENT TOOL).)
2. Move the vehicle to an open space, away from strong winds, and close all of the vehicle doors and windows.
3. Turn the ignition switch to the LOCK position.
4. Disconnect the negative battery cable and wait for 1 min or more.
5. Follow the procedure below for operating (deploying) the applicable air bag module or pre-tensioner seat belt.
AIR BAG SYSTEM
4A 4B 5A 5B
A/B
CRUISE
HORN
No.2
CONTROL
-
+
1A 1B 2A 2B
VEHICLE-SIDE CONNECTOR
2H 2G
*
AIR BAG MODULE-SIDE CONNECTOR
4B 4A
5H 5G
5C 5D
CRUISE ILLUMI- ILLUMI-
CONTROL NATION NATION
- + -
2C 2D
2E 2D 2C 2B 2A
5E 5D 5C 5B 5A
*
5E
5G 5H
AUDIO
AUDIO
CONTROL
CONTROL
+ -
2E
2G 2H
acxuuw00001600
id081000801100
08-10–17
08-10