Mazda CX-7 2007 Workshop Manual page 1079

Toc of SCT
GENERAL PROCEDURES . . . . 06-10
POWER STEERING . . . . . . . . . 06-14
Toc of SCT
06-10 GENERAL PROCEDURES
GENERAL PROCEDURES
(STEERING) . . . . . . . . . . . . . . . . . . . . . 06-10–1
Wheel and Tire Installation . . . . . . . . . . 06-10–1
Power Steering Components
Removal/Installation. . . . . . . . . . . . . . 06-10–1
End of Toc
GENERAL PROCEDURES (STEERING) WM: STEERING
Wheel and Tire Installation
1. When installing the wheels and tires, tighten the
wheel nuts in a criss-cross pattern to the following
tightening torque.
Tightening torque
88.2— 117.6 N·m {9.00— 11.99 kgf·m,
65.06— 86.73 ft·lbf}
Power Steering Components Removal/Installation
1. If any power steering fluid line has been disconnected anytime during the procedure, add ATF M-III, M-V or
equivalent (e.g. Dexron
completed.
Connector Disconnection
1. Disconnect the negative battery cable before performing any work that requires handling of connectors. (See
01-17-2 BATTERY REMOVAL/INSTALLATION[L3 WITH TC])
Suspension Arm Removal/Installation
1. Tighten any part of the suspension that uses rubber bushings only after vehicle has been lowered to the ground
and unloaded.
Note
• Unloaded: Fuel tank is full. Engine coolant and engine oil are at specified level. Spare tire, jack, and tools
are in designated position.
End Of Sie
STEERING
®
II), bleed the fluid lines, and inspect for leakage after the procedure has been
TECHNICAL DATA . . . . . . . . . . 06-50
SERVICE TOOLS . . . . . . . . . . . 06-60
Connector Disconnection . . . . . . . . . . . 06-10–1
Suspension Arm
Removal/Installation . . . . . . . . . . . . . . 06-10–1
4
2
06
SECTION
id061000800100
1
3
5
acxuuw00001552
06-10–1
06-10