Mazda CX-7 2007 Workshop Manual page 1163

13. Install the screw on the end of the phillips
screwdriver with the packing tape.
Caution
• If the packing tape remains in the duct
(2), it may become a source of noise.
Wind up the packing tape to prevent
pinching when tightening the screw.
14. Install the duct (2) to the A/C unit by inserting a
phillips screwdriver, with the screw, into the hole
made after removing the blower motor.
15. Pull out the phillips screwdriver together with the
packing tape.
16. Install in the reverse order of removal.
End Of Sie
BLOWER UNIT DISASSEMBLY/ASSEMBLY
1. Disassemble in the order indicated in the table.
Caution
• Apply only the specified grease to the link. Otherwise abnormal noise or improper operation may
result.
1 Air filter cover
2 Air filter
3 Blower motor
4 Air intake actuator
5 Air intake crank
2. Assemble in the reverse order of disassembly.
End Of Sie
WM: AIR FILTER
BASIC SYSTEM
6
8
5
7
4
2
SCREW
PHILLIPS
SCREWDRIVER
9
3
1
6 Air intake door
7 Polyurethane protector
8 Blower case (1)
9 Blower case (2)
PACKING TAPE
acxuuw00000704
id071100800600
07-11
acxuuw00001562
07-11–11