Mazda CX-7 2007 Workshop Manual page 1019

AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
3. Adjust the length or thermometer probe so that
the length is the same as the depth gauge, and
hold the probe with a paper holder. Insert into the
filler tube and measure the temperature.
• If necessary, inspect the ATF before warming
up the engine. In this case, use the ATF
temperature (15— 25 °C {59— 77 °F}).
4. Warm up the engine until the ATF reaches 60—
70 °C {140— 158 °F}.
5. Shift the selector lever and pause momentarily in
each range (P— D) while depressing the brake
pedal.
6. Shift the selector lever to P position.
7. Verify that the ATF level is in the HOT range (65
°C {149 °F}) while the engine is idling.
• If necessary, add ATF to the specification.
ATF type
JWS3309
End Of Sie
AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT[AW6A-EL, AW6AX-EL]
Warning
• A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool
before replacing the ATF.
1. Remove the oil dipstick.
2. Remove the under cover.
3. Remove the oil drain plug and gasket.
4. Drain the ATF into a container.
5. Install a new gasket and the drain plug.
Tightening torque
23.5— 54.9 N·m {2.4— 5.5 kgf·m, 17.4— 40.4
ft·lbf}
6. Add the specified ATF through the oil filler tube
until it reaches the lower notch of dipstick.
ATF
Type: JWS3309
Capacity (Approx. quantity): 7.0 L {7.4 US qt,
6.2 lmp qt}
7. Install the under cover.
8. Ensure that the ATF level is in the HOT range (65 °C {149 °F}).
• Add ATF to the specified level as necessary.
End Of Sie
TRANSAXLE RANGE (TR) SWITCH INSPECTION[AW6A-EL, AW6AX-EL]
WM: AUTOMATIC TRANSMISSION/TRANSAXLE INPUT (SENSOR/SWITCH)
Note
• TR switch function is installed as one part of TCM.
1. Inspect the TCM. (See 05-17-21 TCM INSPECTION[AW6A-EL, AW6AX-EL].)
End Of Sie
ATF TEMPERATURE
60—70 ˚C {140—158 ˚F}
HOT RANGE
20˚C
65˚C
(REFERENCE)
ATF TEMPERATURE
15—25 ˚C {59—77 ˚F}
acxuuw00000484
05-17
acxuuw00000485
id051723800600
ampjjw00001890
id051723800900
05-17–11