Mazda CX-7 2007 Workshop Manual page 1225

STEP
5 INSPECT WIRING HARNESS BETWEEN PAD
INDICATOR AND SAS CONTROL MODULE
Warning
• Handling the air bag system components
improperly can accidentally deploy the air
bag modules and pre-tensioner front
buckles, which may seriously injure you.
Read the service warnings before handling
the air bag system components.
(See 08-10-3 AIR BAG SYSTEM SERVICE
WARNINGS.)
(See 08-10-5 AIR BAG SYSTEM SERVICE
CAUTIONS.)
• Turn the ignition switch to the LOCK position.
• Disconnect the negative battery cable and wait
for 1 min or more.
• Remove the column cover. (See 09-17-8
COLUMN COVER REMOVAL/INSTALLATION.)
• Disconnect the clock spring connector.
• Remove the glove compartment.(See 09-17-8
GLOVE COMPARTMENT REMOVAL/
INSTALLATION.)
• Disconnect the passenger-side air bag module
connector.
• Disconnect the driver and passenger-side seat
connectors.
• Remove the C-pillar trim. (See 09-17-17 C-
PILLAR TRIM REMOVAL/INSTALLATION.)
• Remove the D-pillar trim. (See 09-17-18 D-
PILLAR TRIM REMOVAL/INSTALLATION.)
• Disconnect the driver and passenger-side
curtain air bag module connector.
• Remove the B-pillar lower trim. (See 09-17-16 B-
PILLAR LOWER TRIM REMOVAL/
INSTALLATION.)
• Disconnect the driver and passenger-side pre-
tensioner seat belt connectors.
• Remove the console. (See 09-17-13 CONSOLE
REMOVAL/INSTALLATION.)
• Disconnect the SAS control module connector.
• Inspect the wiring harness between information
display connector terminal I and SAS control
module connector terminal 1U for the following:
— Short to ground
— Short to power supply
— Open circuit
• Is the wiring harness normal?
6 INSPECT PAD INDICATOR
• Disconnect the SAS control module connector.
• Connect the information display connector.
• Does the PAD indicator illuminate?
End Of Sie
ON-BOARD DIAGNOSTIC
INSPECTION
Yes Go to the next step.
No Replace the air bag wiring harness.
Yes Replace the information display.
(See 09-22-15 INFORMATION DISPLAY REMOVAL/
INSTALLATION.)
No Replace the SAS control module.
(See 08-10-10 SAS CONTROL MODULE REMOVAL/
INSTALLATION.)
ACTION
08-02–23
08-02