Dsc Hu/Cm; Dsc Hu/Cm Connector Removal Note; Brake Pipe Removal Note; Dsc Hu/Cm Installation Note - Mazda CX-7 2007 Workshop Manual

DSC HU/CM Connector Removal Note

1. Pull the lock lever up in the direction of the arrow.
2. Pull the connector toward the vehicle rear and
remove it.

Brake Pipe Removal Note

1. Place an alignment mark on the brake pipe and

DSC HU/CM.

2. Apply protective tape to the connector to prevent
brake fluid from entering.
3. Remove the brake pipe.

DSC HU/CM Installation Note

1. Install the rubber mount on DSC HU/CM section
A to the bracket as shown in the figure.
2. Install DSC HU/CM section B to the bracket.
3. Install the nuts to DSC HU/CM section A and
tighten them.

Brake Pipe Installation Note

1. Align the marks made before removal and install
the brake pipe to the DSC HU/CM and brake pipe
joint referring to the figure.
2. Tighten the brake pipe to the specified torque
using the SST (49 0259 770B) and the
commercially available flare nut wrench.
04-15–8
DYNAMIC STABILITY CONTROL
B
LF
RR
LR
RF
LOCK LEVER
1
2
acxuuw00001149
MARK
MARK
acxuuw00001879
A
acxuuw00001880
MASTER CYLINDER
(SECONDARY SIDE)
MASTER CYLINDER
(PRIMARY SIDE)
acxuuw00001210