Mazda CX-7 2007 Workshop Manual page 1092

Locknut (Adjusting Cover), Adjusting Cover Disassembly Note
1. Install two nuts to the bolt across a flat 24 mm
{0.94 in} and tighten them using a wrench.
2. Secure the adjusting cover with the bolt and nuts
created in Step 1, and remove the locknut using
the SST.
Caution
• If a tool such as a torque wrench is
installed to the SST (49 E032 308), install
the tool so that it is perpendicular to the
SST as shown in the figure. If the tool is
not installed as instructed, the SST can
separate from the locknut easily which
could cause damage to the locknut while
doing the work.
3. Using the bolt/nut produced in Step 1, remove the
adjusting cover.
Pinion Shaft, Oil seal (lower side) Disassembly Note
1. Press out the pinion shaft and oil seal (lower side)
component.
Bearing (upper side), Oil seal (upper side) Disassembly Note
1. Press out the upper bearing and oil seal from the
valve housing using the SSTs.
Substitution SST
• 49 G033 102
Outer diameter: 23— 24 mm {0.91— 0.94 in}
06-14–12
2007 Mazda CX-7 Workshop Manual (1871–1U–06B)
POWER STEERING
49 E032 308
NUT
BOLT
ACROSS FLAT 24 mm {0.94 in}
Revised 7/2006 (Ref. No. R065/06)
49 E032 308
acxuuw00002547
acxuuw00000953
49 G033 102
49 B032 301
acxuuw00001156