Mazda CX-7 2007 Workshop Manual page 1181

EVAPORATOR TEMPERATURE SENSOR INSPECTION
1. Set the fan speed MAX HI.
2. Set the temperature control at MAX COLD (Turn the left).
3. Turn the A/C switch off.
4. Set the RECIRCULATE mode.
5. Close all doors and windows.
6. Wait for 5 min.
7. Remove the glove compartment. (See 09-17-8 GLOVE COMPARTMENT REMOVAL/INSTALLATION.)
8. Disconnect the evaporator temperature sensor connector.
9. Measure the temperature at the blower inlet.
10. Measure the resistance between terminals of the
evaporator temperature sensor.
• If the resistance is not as shown in the graph,
replace the evaporator temperature sensor.
End Of Sie
WM: AIR INTAKE ACTUATOR
AIR INTAKE ACTUATOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the glove compartment. (See 09-17-8 GLOVE COMPARTMENT REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
1 Air intake actuator connector
2 Air intake actuator
4. Install in the reverse order of removal.
End Of Sie
CONTROL SYSTEM
KILOHM
16
14
12
10
8
6
4
2
0
-10
{14}
0 10 20 30
{32} {50} {68} {86}
TEMPERATURE
1
2
id074000801200
07-40
40 50 { F}
C
{104} {122}
acxuuw00000978
id074000801400
acxuuw00001566
07-40–9