Mazda CX-7 2007 Workshop Manual page 439

10. Remove the ignition coils. (See 01-18-2 IGNITION COIL REMOVAL/INSTALLATION[L3 WITH TC].)
11. Loosen the water pump pulley bolts before removing the drive belt.
12. Remove the drive belt. (See 01-10-3 DRIVE BELT REMOVAL/INSTALLATION[L3 WITH TC].)
13. Remove the P/S oil pump with hose and pipe still connected. Position the P/S oil pump out of the way. (See 06-
14-21 POWER STEERING OIL PUMP REMOVAL/INSTALLATION.)
14. Remove the crankshaft position (CKP) sensor. (See 01-40-42 CRANKSHAFT POSITION (CKP) SENSOR
REMOVAL/INSTALLATION[L3 WITH TC].)
15. Remove the engine front cover. (See 01-10-10 TIMING CHAIN REMOVAL/INSTALLATION[L3 WITH TC].)
16. Remove in the order indicated in the table.
17. Install in the reverse order of removal.
18. Refill with the specified type and amount of the engine oil. (See 01-11-4 ENGINE OIL REPLACEMENT[L3
WITH TC].)
19. Refill the engine coolant. (See 01-12-5 ENGINE COOLANT REPLACEMENT[L3 WITH TC].)
20. Start the engine and confirm that there is no oil leakage.
• If there is oil leakage, repair or replace the applicable part.
21. Inspect the oil level. (See 01-11-3 ENGINE OIL LEVEL INSPECTION[L3 WITH TC].)
22. Inspect for engine coolant leakage. (See 01-12-6 ENGINE COOLANT LEAKAGE INSPECTION[L3 WITH TC].)
23. Inspect for the ignition timing and idle speed. (See 01-10-35 ENGINE TUNE-UP[L3 WITH TC].)
3
17—23 {1.8—2.3, 12.6—16.9}
37—52 {3.8—5.3, 28—38}
.
1 Dipstick pipe
2 O-ring
Oil Pan Removal Note
1. Remove the oil pan using a separator tool.
LUBRICATION [L3 WITH TC]
A
SEALANT
17—23 {1.8—2.3, 12.6—16.9}
3
37—52 {3.8—5.3,
28—38}
8.0—11.5
{82—117 kgf·cm,
71—101 in·lbf}
A
Oil pan
(See 01-11-7 Oil Pan Removal Note.)
(See 01-11-8 Oil Pan Installation Note.)
01-11
N·m
R
N·m {kgf·m, ft·lbf}
acxuuw00001991
acxuuw00001992
01-11–7