Mazda CX-7 2007 Workshop Manual page 1287

6. Connect the SST (Deployment tool) to the SST
(Adapter harness).
7. Connect the SST (Deployment tool) to the
battery. Connect the power supply red clip to the
positive battery terminal, and the black clip to the
negative battery terminal.
8. Verify that the red lamp on the SST (Deployment
tool) is illuminated.
9. Verify that all persons are standing at least 6 m
{20 ft} away from the vehicle.
10. Press the activation switch on the SST
(Deployment tool) to operate (deploy) the side
air bag module.
11. Disconnect the SSTs (Deployment tool) from the
SSTs (Adapter harness).
Curtain Air Bag Module
1. Remove the curtain air bag module.
(See 08-10-8 CURTAIN AIR BAG MODULE REMOVAL/INSTALLATION.)
2. Secure the curtain air bag module in a vise, and
cut off the deployment section, as shown in the
figure.
Warning
• Be sure not to crush the pipe on the side
where it is cut. If it is crushed completely,
the interior pressure of the pipe will build
up and can cause it to explode during air
bag module operation (deployment).
3. Connect the SST (Adapter harness) to the
curtain air bag module as shown in the figure.
AIR BAG SYSTEM
49 H066 002
49 H066 002
CUT
49 L066 002
49 L066 002
400 mm {15.7 in} OR MORE
CURTAIN AIR BAG
MODULE
CURTAIN AIR BAG
MODULE
acxuuw00001285
ACTIVATION
SWITCH
acxuuw00001267
08-10
acxuuw00001713
acxuuw00001714
08-10–27