Mazda CX-7 2007 Workshop Manual page 1099

Oil Seal (lower side) Assembly Note
1. Assemble the oil seal (lower side) using the SST.
Substitution SST
• 49 L032 312A
Outer diameter: 35— 36 mm {1.2— 1.3 in}
Cylindrical shape outer diameter of 40 mm
{1.6 in} or more.
Pinion Shaft Assembly Note
1. Assemble the pinion shaft using a press.
Housing Cover Assembly Note
1. Apply silicone sealant to the threads of the housing cover.
2. Assemble the housing cover.
Dust cover Assembly Note
1. Apply grease to the oil dust cover shown in the
figure.
Specified grease
• Rubber grease (Mazda genuine parts) or
equivalent.
Adjusting Cover, Locknut (Adjusting Cover) Assembly Note
1. Install two nuts to the bolt across a flat 24 mm
{0.94 in} and tighten them using a wrench.
2. Using the bolt/nut produced in Step 1, install the
adjusting cover.
(1) Tighten the adjusting cover with a tightening
torque of 20.0 N·m {2.0 kgf·m, 14.8 ft·lbf}.
Revised 7/2006 (Ref. No. R065/06)
2007 Mazda CX-7 Workshop Manual (1871–1U–06B)
POWER STEERING
49 L032 312A
acxuuw00001007
acxuuw00001006
acxuuw00002261
NUT
BOLT
ACROSS FLAT 24 mm {0.94 in}
acxuuw00002544
06-14–19
06-14