Mazda CX-7 2007 Workshop Manual page 1289

11. Press the activation switch on the SST
(Deployment tool) to operate (deploy) the curtain
air bag module.
12. Disconnect the SSTs (Deployment tool) from the
SSTs (Adapter harness).
Pre-tensioner Seat Belt
1. Remove the pre-tensioner seat belt.
(See 08-11-2 FRONT SEAT BELT REMOVAL/INSTALLATION.)
2. Connect the SST (Adapter harness) to the pre-
tensioner seat belt as shown in the figure.
3. Put the pre-tensioner seat belt inside the tire and
secure it to the tire by wrapping a wire (cross
2
section of 1.25mm {0.002in
the tire and the bolt installation holes at least 4
times.
Warning
• If the pre-tensioner seat belt is not
properly installed to the tire, serious
injury may occur when the pre-tensioner
part is operated (deployed). When
installing the pre-tensioner seat belt to
the tire, make sure the pre-tensioner part
is inside the tire.
4. Stack the tire with the pre-tensioner seat belt on
to of two tires without wheels. Stack a tire without
a wheel on top of the tire with the pre-tensioner
seat belt, and then stack another tire with a wheel
on the very top.
AIR BAG SYSTEM
2
} or more) through
49 H066 002
49 L066 002
TIRE
TIRE
WITHOUT
WHEEL
ACTIVATION
SWITCH
acxuuw00001267
08-10
acxuuw00001273
WIRE
PRE-TENSIONER
SEAT BELT
acxuuw00001291
TIRE WITH
WHEEL
TIRE WITH
PRE-TENSIONER
SEAT BELT
acxuuw00001292
08-10–29