Mazda CX-7 2007 Workshop Manual page 1033

AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
Terminal Signal Connected to
Shift solenoid Shift solenoid
B22
E control GND E
End Of Sie
TCM REMOVAL/INSTALLATION[AW6A-EL, AW6AX-EL]
Caution
• Water or foreign material entering the connector can cause a poor connection or corrosion. Be
sure not to allow water or foreign material on the connector when disconnecting.
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. (See 01-13-5 INTAKE AIR SYSTEM REMOVAL/INSTALLATION[L3 WITH
TC].)
3. Disconnect the TCM connector.
4. Remove the clip and disconnect the selector
cable.
Caution
• Do not use an impact wrench. Hold the
manual shaft lever when removing the
manual shaft nut, or the transaxle may be
damaged.
5. Set the adjustable wrench as shown in the figure
to hold the manual shaft lever.
6. Remove the manual shaft nut and washer.
Test Condition
• Inspect
resistance
between couple
ATF
component
temperature:
terminals
20°C {68°F}
B14and B22
(wiring harness-
side).
CLIP
TCM
MANUAL
SHAFT
LEVER
MANUAL SHAFT LEVER
MANUAL
SHAFT NUT
WASHER
MANUAL
SHAFT
LEVER
TCM
Continuity/
Inspection item (s)
Resistance
• Inspect shift solenoid E
(See 05-17-20
5.0— 5.6 SOLENOID VALVE
(ohms) INSPECTION[AW6A-EL,
AW6AX-EL])
• Inspect related harness
ADJUSTABLE WRENCH
05-17–25
id051723800400
05-17
SELECTOR
CABLE
acxuuw00000523
acxuuw00000524
acxuuw00000525