Rear Coil Spring Installation Note - Mazda CX-7 2007 Workshop Manual

4. Support the lower arm with a jack.
5. Loosen the inner bolt of the lower arm.
6. Remove the outer bolt of the lower arm.
7. Jack down slowly and remove the coil spring.
Warning
• Removing the coil spring is dangerous.
The coil spring could fly off, the cause
serious injury or death.

Rear Coil Spring Installation Note

1. Position the jack under the lower arm and jack up slowly.
Warning
• Installing the coil spring is dangerous. The coil spring could fly off, and cause serious injury or
death.
2. Install the lower arm (outer side) bolt.
3. Raise the rear trailing link to the unloaded condition with a jack.
4. Tighten the outer bolt of the upper arm.
Tightening torque
• 75.5— 102 N·m {10.0— 12.2 kgf·m, 72.3— 75.2 ft·lbf}
5. Tighten the inner and outer bolts of the lateral link.
Tightening torque
• 75.5— 102 N·m {10.0— 12.2 kgf·m, 72.3— 75.2 ft·lbf}
End Of Sie
WM: REAR LOWER ARM
REAR SUSPENSION
JACK
acxuuw00002442
02-14–7
02-14