Mazda CX-7 2007 Workshop Manual page 1271

2007 mazda cx-7
Hide thumbs Also See for CX-7 2007:
Table of Contents

Advertisement

3. Disconnect the negative battery cable and wait for 1 min or more.
4. Remove the console panel. (See 09-17-15 CONSOLE PANEL REMOVAL/INSTALLATION.)
5. Remove the console. (See 09-17-13 CONSOLE REMOVAL/INSTALLATION.)
6. Remove in the order indicated in the table.
1
Connector
2
Nut
3
SAS control module
7. Install in the reverse order of removal.
8. Turn the ignition switch to the ON position.
• If the SAS control module is replaced, turn the
ignition switch to the ON position for 20 s or
more after completing the configuration. (See
08-10-11 SAS CONTROL MODULE
CONFIGURATION.)
9. Verify that the air bag system warning light
illuminates for approx. 6 s and goes out.
• If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air
bag system) and perform inspection of the system.
End Of Sie
SAS CONTROL MODULE CONFIGURATION
1. Connect the M-MDS to the DLC-2 connector.
2. After the vehicle is identified, select the following
items from the initialization screen of the M-MDS.
• When using the IDS (notebook PC)
1. Select "Module Programming".
• When using the PDS (pocket PC)
1. Select "Programming".
2. Select "Module Programming".
3. Then, select items from the screen menu in the
following order.
1. Select "Programmable Module Installation".
2. Select "RCM".
4. Perform the configuration according to the
directions on the screen.
End Of Sie
SEAT WEIGHT SENSOR CONTROL MODULE REMOVAL/INSTALLATION
Caution
• When the seat weight sensor control module is replaced with a new one, perform the seat weight
sensor calibration using the M-MDS. (See 08-10-12 SEAT WEIGHT SENSOR CALIBRATION.)
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable and wait for1 min or more.
3. Remove the front passenger's seat. (See 09-13-2 FRONT SEAT REMOVAL/INSTALLATION.)
4. Remove in the order indicated in the table.
1
Connector
2
Fastener
3
Seat weight sensor control module
5. Install in the reverse order of removal.
End Of Sie
AIR BAG SYSTEM
8.8—12.8
{89.8—130.5,
77.8—113.2}
2
3
1
N·m {kgf·cm, in·lbf}
DLC-2
2
1
08-10–11
acxuuw00000646
id081000801500
08-10
acxuuw00000647
id081000801600
3
acxuuw00000648

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents