Mazda CX-7 2007 Workshop Manual page 431

7. Tighten the No.4 engine mount bracket in the
order shown in the figure.
Tightening torque
Installation
Position
66.6— 93.1 N·m {6.8— 9.4 kgf·m, 50—
13
74.5— 104.9 N·m {7.6— 10.6 kgf·m,
4
8. Tighten the No.1 engine mount bolt A shown in
the figure
Tightening torque
85.3— 116.6 N·m {8.7— 11.8 kgf·m, 63.0—
85.9 ft·lbf}
End Of Sie
ENGINE DISASSEMBLY/ASSEMBLY[L3 WITH TC]
1. Remove the engine from the transaxle. (See05-17-29 AUTOMATIC TRANSAXLE REMOVAL/
INSTALLATION[AW6A-EL, AW6AX-EL].)
2. Remove the intake-air system. (See01-13-5 INTAKE AIR SYSTEM REMOVAL/INSTALLATION[L3 WITH TC].)
3. Remove the exhaust system. (See01-15-2 EXHAUST SYSTEM REMOVAL/INSTALLATION[L3 WITH TC].)
4. Remove the generator. (See01-17-4 GENERATOR REMOVAL/INSTALLATION[L3 WITH TC].)
5. Remove the starter. (See01-19-2 STARTER REMOVAL/INSTALLATION[L3 WITH TC].)
6. Remove the crankshaft position (CKP) sensor. (See01-40-42 CRANKSHAFT POSITION (CKP) SENSOR
REMOVAL/INSTALLATION[L3 WITH TC].)
7. Install in the reverse order of removal.
End Of Sie
ENGINE TUNE-UP[L3 WITH TC]
Note
• If the accelerator pedal is depressed continuously for a specified time, the engine speed may decrease to
the idle speed. This is due to the fuel cut control operation, which prevents overheating, and it does not
indicate a malfunction.
Engine Tune-up Preparation
1. Verify that the selector lever is in P, N position.
2. Connect the M-MDS to the DLC-2.
3. Verify that no DTCs are available.
4. Warm up the engine (ECT is approx. 80°C {176
°F} or more).
5. Turn off the electrical loads.
6. Wait until the cooling fans stop.
MECHANICAL [L3 WITH TC]
Tightening Torque
68 ft·lbf}
55.0— 77.3 ft·lbf}
3
1
A
DLC-2
01-10
FRONT
acxuuw00000193
FRONT
acxuuw00000194
id011039800500
id011039800600
acxuuw00000150
01-10–35