Mazda CX-7 2007 Workshop Manual page 1093

Clip Disassembly Note
1. Remove the clip while pinching both ends of the
clip using long-nose pliers as shown in the figure.
2. Using a snap ring plier, withdraw the rack stopper.
Oil Seal Disassembly Note
1. Install the SST (49 N032 319A) to the gear
housing with the raised part facing up as shown in
the figure.
2. Insert the SSTs (49 F032 303, 49 S032 318) into
the valve housing side.
3. Remove the oil seal using a press.
Mounting Rubber Disassembly Note
1. Press the mounting rubber out from the gear
housing using the SSTs and a press.
Substitution SST
• 49 B018 003
Outer diameter: 36— 38 mm {1.42— 1.49 in}
• 49 B032 317
Outer diameter: 35mm {1.4 in} or more
End Of Sie
STEERING GEAR AND LINKAGE INSPECTION
Steering Rack Inspection
1. Inspect for cracking, damage, and tooth wear.
• If there is any malfunction, replace the steering rack.
2. Measure the steering rack warp.
• If it exceeds the maximum specification,
replace the steering rack.
Steering rack runout
Large diameter portion (near point A): 0.15
mm {0.006 in} max.
Small diameter portion (near point B): 0.20
mm {0.008 in} max.
2007 Mazda CX-7 Workshop Manual (1871–1U–06B)
POWER STEERING
END OF
THE CLIP
49 N032 319A
49 B032 317
49 B018 003
B
CLIP
RACK STOPPER
acxuuw00001605
49 F032 303
06-14
49 S032 318
acxuuw00000954
acxuuw00000955
id061400801100
A
acxuuw00001775
06-14–13