Mazda CX-7 2007 Workshop Manual page 1282

8. Press the activation switch on the SST
(Deployment tool) to operate (deploy) the pre-
tensioner seat belt.
9. Disconnect the SSTs (Deployment tool) from the
SSTs (Adapter harness).
Deployment Procedure for Outside of Vehicle
1. Inspect the SST (Deployment tool).
(See 08-10-31 INSPECTION OF SST (DEPLOYMENT TOOL).)
2. Turn the ignition switch to the LOCK position.
3. Disconnect the negative battery cable and wait for 1 min or more.
4. Follow the procedure below for operating (deploying) the applicable air bag module or pre-tensioner seat belt.
Driver-side Air Bag Module
Warning
• The driver-side air bag module is a dual inflator type. If one inflator is forced to operate (deploy),
the other may operate (deploy) accidentally. To prevent injury while disposing of the air bag
module, make sure to operate (deploy) both driver-side air bag module inflators simultaneously,
following the procedure below.
1. Remove the driver-side air bag module.
(See 08-10-6 DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION.)
2. Connect the SSTs (Adapter harness) to the
driver-side air bag module as shown in the figure.
3. Place the driver-side air bag module on the center
of the tire wheel with the padded surface facing
up. To secure the air bag module to the tire wheel,
wrap a wire (cross section 1.25 mm
or more) through the wheel and the bolt
installation holes of the air bag module at least 4
times.
Warning
• If the air bag module is not properly
installed to the tire wheel, serious injury
may occur when the module is operated
(deployed). When installing the air bag
module to the tire wheel, make sure the
padded surface is facing up.
08-10–22
AIR BAG SYSTEM
49 H066 002
2 2
{0.002 in }
ACTIVATION
SWITCH
49 L066 002
49 G066 003
DRIVER-SIDE AIR BAG MODULE
WIRE
acxuuw00001267
acxuuw00001396
acxuuw00001274