Mazda CX-7 2007 Workshop Manual page 1045

AUTOMATIC TRANSAXLE [AW6A-EL, AW6AX-EL]
Converter housing side (AWD)
Substitution SST
• 49 L033 101
Outer diameter: 73— 76.3 mm {2.88— 3.00
in}
Inner diameter: 69 mm {2.72 in} or more
Plate thickness: 2 mm {0.08 in} or more
Length: 20 mm {0.79 in} or more
10. Install the joint shaft. (2WD) (See 03-13-3 JOINT
SHAFT REMOVAL/INSTALLATION[2WD].)
11. Install the transfer and joint shaft. (AWD) (See 03-
13-4 JOINT SHAFT REMOVAL/
INSTALLATION[AWD].) (See 03-16-3
TRANSFER REMOVAL/INSTALLATION.)
12. Install the drive shaft. (See 03-13-12 FRONT
DRIVE SHAFT REMOVAL/INSTALLATION.)
13. Add ATF to the specified level. (See 05-17-11 AUTOMATIC TRANSAXLE FLUID (ATF)
REPLACEMENT[AW6A-EL, AW6AX-EL].)
14. Connect the negative cable.
15. Perform the mechanical system test. (See 05-17-3 MECHANICAL SYSTEM TEST[AW6A-EL, AW6AX-EL].)
End Of Sie
DIFFERENTIAL GEAR O-RING REPLACEMENT[AW6A-EL, AW6AX-EL]
Caution
• The O-ring is easily damaged by the sharp edges of the drive shaft splines. Do not let the splines
contact the O-ring.
1. Remove the drive shaft and joint shaft. (See 03-13-3 JOINT SHAFT REMOVAL/INSTALLATION[2WD].) (See
03-13-4 JOINT SHAFT REMOVAL/INSTALLATION[AWD].) (See 03-13-12 FRONT DRIVE SHAFT REMOVAL/
INSTALLATION.)
Caution
• Do not damage the differential case.
2. Remove and discard the O-ring using a tape-
wrapped flathead screwdriver.
Caution
• Do not damage the O-ring.
• Do not damage the differential case.
3. Apply ATF to a new O-ring and install it to the
differential case.
4. Install the drive shaft and joint shaft. (See 03-13-3
JOINT SHAFT REMOVAL/
INSTALLATION[2WD].) (See 03-13-4 JOINT
SHAFT REMOVAL/INSTALLATION[AWD].) (See
03-13-12 FRONT DRIVE SHAFT REMOVAL/
INSTALLATION.)
End Of Sie
WM: CONTROL VALVE BODY
49 L033 101
7.4—8.4 mm
{0.292—0.330 in}
acxuuw00002290
05-17
id051723800200
acxuuw00000543
05-17–37