Pcm Removal/Installation; Pcm Connector Connection Note - Mazda CX-7 2007 Workshop Manual

PCM REMOVAL/INSTALLATION[L3 WITH TC]
Note
• For PCM replacement, set up the M-MDS and perform the PCM configuration. (See 01-40-21 PCM
CONFIGURATION[L3 WITH TC].)
1. Disconnect the negative battery cable.
2. Remove the charge air cooler duct. (See01-13-5 INTAKE AIR SYSTEM REMOVAL/INSTALLATION[L3 WITH
TC].)
3. Remove the Battery and battery tray. (See01-17-2 BATTERY REMOVAL/INSTALLATION[L3 WITH TC].)
4. Remove the mudguard (LH).
5. Remove in the order indicated in the table.
6. When replacing the PCM on the vehicles, perform the following.
• PCM parameter reset (See09-14-11 IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY
ADDITION AND CLEARING[ADVANCED KEYLESS SYSTEM].) (See09-14-20 IMMOBILIZER SYSTEM
COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING[KEYLESS ENTRY SYSTEM].)
7. Install in the reverse order of removal.
A
7.8—10.8
{80—110, 69—95}
2
7.8—10.8
{80—110, 69—95}
1 PCM connector
(See 01-40-6 PCM Connector Connection Note.)

PCM Connector Connection Note

Caution
• If the PCM connector is inserted at an
angle and the lever is moved, the
connector could be damaged. Verify that
the PCM connector is inserted straight.
End Of Sie
01-40–6
2007 Mazda CX-7 Workshop Manual (1871–1U–06B)
CONTROL SYSTEM [L3 WITH TC]
7.8—10.8
{80—110,
69—95}
3
1
7.8—10.8
{80—110, 69—95}
N·m {kgf·cm, in·lbf}
VIEW FROM A
FRONT
FRONT TIRE (LH) SIDE
2 PCM
3 PCM bracket
Revised 12/2006 (Ref. No. R215/06)
id014039802400
acxuuw00001858
acxaaw00000768