Mazda CX-7 2007 Workshop Manual page 488

6. Start the fuel pump using the following procedure.
Using M-MDS
1. Connect the M-MDS to the DLC-2.
2. Using the simulation function "FP", start the
fuel pump.
Without using M-MDS
1. Remove the fuel pump relay.
Caution
• Short the specified terminals because
shorting the wrong terminal of the main
fuse block may cause malfunctions.
2. Using a jumper wire, short fuel pump relay
terminals C and D in the main fuse block.
3. Connect the negative battery cable and
operate the fuel pump.
Caution
• The fuel pump could be damaged if it is
operated (fuel pump idling) while there is
no fuel in the fuel tank. Verify the amount
of fuel being discharged from the hose
and stop operation of the fuel pump
when essentially no fuel is being
discharged.
7. When essentially no fuel is being discharged, stop the fuel pump.
Using M-MDS
1. Using the simulation function "FP", stop the fuel pump.
Without using M-MDS
1. Turn the ignition switch to LOCK position to stop the fuel pump.
2. Disconnect the jumper wire from the check connector.
8. Disconnect the negative battery cable.
9. Remove the fuel pump bracket installation screws.
10. Remove in the order indicated in the table.
1 Connector
2 Quick release connector
(See01-14-19 QUICK RELEASE CONNECTOR
REMOVAL/INSTALLATION[L3 WITH TC])
3 Quick release connector
(See01-14-19 QUICK RELEASE CONNECTOR
REMOVAL/INSTALLATION[L3 WITH TC])
11. Install in the reverse order of removal.
12. Complete the "AFTER REPAIR PROCEDURE". (See01-14-4 AFTER REPAIR PROCEDURE[L3 WITH TC].)
End Of Sie
01-14–12
FUEL SYSTEM [L3 WITH TC]
1
3
DLC-2
MAIN FUSE BLOCK
(FUEL PUMP RELAY)
A
C
D
6
5
R
2
4
4 Fuel pump unit
5 Packing
6 Fuel pump bracket
acxuuw00000288
E
acxuuw00000183
acxuuw00000289