Mazda CX-7 2007 Workshop Manual page 1213

STEP
3 INSPECT FLOOR
• Visually inspect the installation parts of the
passenger-side seat for the following:
— Abnormal floor deformation
— Installation hole of passenger-side seat is
improperly positioned
• Is the floor normal?
4 INSPECT SEAT WEIGHT SENSOR CONTROL
MODULE
• Replace the seat weight sensor.
• After replacement, perform seat weight
sensor calibration. (See 08-10-12 SEAT
WEIGHT SENSOR CALIBRATION.)
• Reperform the DTC inspection.
• Is DTC B1013 indicated?
End Of Sie
DTC B1017
DTC B1017 Deployment prohibited because configuration is not set
Warning
• Detection conditions are for understanding the DTC outline before performing an inspection.
Performing an inspection according to only the detection conditions may cause injury due to
DETECTION
an operating error, or damage the system. When performing an inspection, always follow the
CONDITION
inspection procedure.
• SAS control module configuration has not been set.
• SAS control module configuration has not been set
POSSIBLE
• SAS control module malfunction
CAUSE
Diagnostic procedure
STEP
1 CONFIGURATION
• Using the M-MDS perform SAS control
module configuration. (See 08-10-11 SAS
CONTROL MODULE CONFIGURATION.)
• Turn the ignition switch to the ON position.
• Is DTC B1017 indicated?
2 INSPECT SAS CONTROL MODULE
• Using the M-MDS perform SAS control
module configuration. (See 08-10-11 SAS
CONTROL MODULE CONFIGURATION.)
• Turn the ignition switch to the ON position.
• Is DTC B1017 indicated?
End Of Sie
ON-BOARD DIAGNOSTIC
INSPECTION
INSPECTION
Yes Go to the next step.
No Repair floor deformation.
• After repair, perform seat weight sensor calibration
and reperform the DTC inspection. If the DTC is
displayed even though the floor has been repaired, go
the next step. (See 08-10-12 SEAT WEIGHT
SENSOR CALIBRATION.)
Yes Replace the seat weight sensor control module.
(See 08-10-11 SEAT WEIGHT SENSOR CONTROL
MODULE REMOVAL/INSTALLATION.)
• After replacement, perform seat weight sensor
calibration and reperform the DTC inspection. If the
DTC is displayed even though the seat weight sensor
control module has been replaced, replace the SAS
control module. (See 08-10-10 SAS CONTROL
MODULE REMOVAL/INSTALLATION.)
No DTC troubleshooting completed.
[Present malfunction diagnosis]
Yes
• When only DTC B1017 is displayed:
— Go to the next step.
• When DTCs except B1017 are also displayed:
— Perform troubleshooting according to the
corresponding DTC inspection (except DTC
B1017).
[Past malfunction diagnosis]
• DTC troubleshooting completed.
No DTC troubleshooting completed.
Yes [Present malfunction diagnosis]
• Replace the SAS control module.
(See 08-10-10 SAS CONTROL MODULE REMOVAL/
INSTALLATION.)
[Past malfunction diagnosis]
• DTC troubleshooting completed.
No DTC troubleshooting completed.
ACTION
id080200820000
ACTION
08-02–11
08-02