Mazda CX-7 2007 Workshop Manual page 420

3. To position the crankshaft pulley, temporarily
tighten it and, using a suitable bolt (M6 x 1.0), fix
the crankshaft pulley to the engine front cover.
4. Install the SSTs to the crankshaft pulley and lock
the crankshaft against rotation, and tighten the
crankshaft pulley lock bolt using the following two
steps.
Tightening procedure
(1) 96— 104 N·m {9.8— 10.6 kgf·m, 70.9—
76.7 ft·lbf}
(2) 87°— 93°
5. Remove the crankshaft pulley installation bolt (M6
X 1.0).
6. Remove the SST from the camshaft.
7. Remove the SST installed in the cylinder block
lower blind plug hole.
8. Rotate the crankshaft clockwise two turns and inspect the valve timing.
• If not aligned, repeat from Step 1.
9. Install the cylinder block lower blind plug.
Tightening torque
18— 22 N·m {1.9— 2.2 kgf·m, 14— 16 ft·lbf}
End Of Sie
WM: REAR OIL SEAL
REAR OIL SEAL REPLACEMENT[L3 WITH TC]
1. Remove the drive plate. (See 05-17-52 DRIVE PLATE REMOVAL/INSTALLATION[AW6A-EL, AW6AX-EL].)
2. Remove in the order indicated in the figure.
3. Install in the reverse order of removal.
1 Bolt
2 Rear oil seal
(See01-10-27 Rear Oil Seal Installation Note.)
01-10–26
MECHANICAL [L3 WITH TC]
8.0—11.5
{82—117,
71—101}
205-126
BLIND
PLUG
1
BOLT
acxuuw00000203
205-07202
acxuuw00002079
acxuuw00000204
id011039800900
8.0—11.5
{82—117,
71—101}
1
OIL
SST
R
2
N·m {kgf·cm, in·lbf}
acxuuw00000146