Mazda CX-7 2007 Workshop Manual page 536

2007 mazda cx-7
Hide thumbs Also See for CX-7 2007:
Table of Contents

Advertisement

Brush spring
1. Measure the force of the brush spring using a spring pressure gauge.
2. Read the spring pressure gauge at the brush tip
projection of 2 mm {0.079 in}.
• Replace the brush spring if necessary.
Generator brush spring force
Standard: 4.1— 5.3 N {0.42— 0.54 kgf, 0.92—
1.19 lbf}
Minimum: 1.7 N {0.17 kgf, 0.38 lbf}
Rectifier (Using an analog circuit tester)
1. Inspect for continuity of the diodes using an
analog circuit tester.
• If not as specified, replace the rectifier.
Specification
Negative
Positive
E
P1, P2, P3, P4,
P5, P6
B
P1, P2, P3, P4,
P5, P6
Rectifier (Using a digital circuit tester)
1. Inspect for continuity of the diodes using a digital circuit tester.
• If not as specified, replace the rectifier.
Specification
Negative
Positive
E
P1, P2, P3, P4,
P5, P6
B
P1, P2, P3, P4,
P5, P6
Bearing
1. Inspect for abnormal noise, looseness, and
sticking.
• Replace the bearing if necessary.
End Of Sie
01-17–10
CHARGING SYSTEM [L3 WITH TC]
Continuity
Yes
No
E
No
B
Yes
Continuity
No
Yes
E
Yes
B
No
2 mm
{0.079 in}
P4
P3
P2
P1
E
acxuuw00002027
P5
P6
B
acxuuw00002028
acxuuw00002029

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents