File System Prompt Mode Setting; File System Operations Example - H3C S3610-28P Operation Manual

Operation Manual – File System Management
H3C S3610&S5510 Series Ethernet Switches
Caution:
When you format a storage device, all the files stored on it are erased and cannot be
restored. In particular, if there is a startup configuration file on the storage device,
formatting the storage device results in loss of the startup configuration file.

1.1.5 File System Prompt Mode Setting

The file system provides the following two prompt modes:
alert: where the system warns you about operations that may bring undesirable
consequence such as file corruption or data loss.
quiet: where the system does not do that in any cases.
To prevent undesirable consequence resulted from misoperations, the alert mode is
preferred.
Enter system view
Set the operation prompt
mode of the file system

1.1.6 File System Operations Example

# Display the files and the subdirectory under the current directory.
<Sysname> dir
Directory of flash:/
0 drw-
1 -rw-
2 drw-
3 -rw-
14605 KB total (6890 KB free)
# Create a new folder called mytest under the test directory.
<Sysname> cd test
<Sysname> mkdir mytest
%Created dir flash:/test/mytest.
# Display the current working directory.
<Sysname> pwd
To do...
system-view
file prompt { alert |
quiet }
- Feb 16 2006 11:45:36
1218 Feb 16 2006 11:46:19
- Feb 16 2006 15:20:27
184108 Feb 16 2006 15:30:20
Chapter 1 File System Management Configuration
Use the command...
logfile
config.cfg
test
aaa.bin
1-5
Remarks
—
Optional
The default is alert.