Extreme Networks ExtremeWare XOS Command Reference Manual page 1678

Troubleshooting Commands
Diagnostics never run
If you try to display diagnostic test information on a slot where no module is installed, the switch
displays a message similar to the following:
No card in slot
Running Diagnostics. To run diagnostics on an I/O module or an MSM installed in a modular switch,
use the following command:
run diagnostics [extended | normal] slot [<slot> | A | B]
To run diagnostics on the Summit X450 switch, use the following command:
run diagnostics [extended | normal]
Depending on the software version running on your switch or your switch model, additional or
different diagnostic information might be displayed. For more information, see the command
diagnostics
Example
The following command displays the results of module diagnostics for the I/O module in slot 1:
show diagnostics slot 2
The following is sample output from the BlackDiamond 10K switch:
Slotnum 2
DiagResult timestamp Fri Oct
Test Temperature = 34 degrees C
Diag Test Version=1.0.4.2.
------------------------------------------------------------------------
CPU System |
------------------------------------------------------------------------
Register Test |
------------------------------------------------------------------------
Memory Test |
------------------------------------------------------------------------
System Test |
------------------------------------------------------------------------
Last Fail: Never
Summary: Diagnostics Pass
The following is sample output from the BlackDiamond 8800 family of switches:
Last Fail: Never
Summary: Diagnostics Pass
The following command displays the results of the switch diagnostics for the Summit X450 switch:
show diagnostics
The following is sample output from this command:
Last Fail: Never
Summary: Diagnostics Pass
1678
on page 1668.
8 10:09:02 2004
Passed
Passed
Passed
Passed
S/N=0646F-01234
ExtremeWare XOS 11.3 Command Reference
run