Show Elrp - Extreme Networks ExtremeWare XOS Command Reference Manual

Troubleshooting Commands

show elrp

show elrp
Description
Displays ELRP information.
Syntax Description
This command has no arguments or variables.
Default
N/A.
Usage Guidelines
If you enter the
State of ELRP (enabled/disabled).
●
Total number of ELRP sessions.
●
ELRP packets transmitted.
●
ELRP packets received.
●
In addition to the summary information at the top of the display, the
displays the following information:
Client
VLAN
Ports
Interval
Count
Cyclic
Pkts-Xmit
Pkts-Rcvd
1680
command, this command displays the:
show elrp
Displays the name of the ELRP client.
Displays the name of the VLAN with ELRP enabled.
Displays the set of VLAN ports used for packet transmission.
Displays the configured interval. An interval of 3 indicates that ELRP PDUs are transmitted
every 3 seconds.
Lists the configured number of ELRP PDUs that are transmitted. The PDUs are transmitted at
the configured interval. This method of ELRP PDU transmission is used by ESRP in the pre-
master state. A count of 0 indicates continuous PDU transmission. If the Cyclic value is Yes,
the count is always 0.
Indicates whether ELRP PDUs are being continuously sent. The column shows Yes for the
master VLAN because that VLAN is continuously sending ELRP PDUs for loop detection. When
a VLAN is in the pre-master state, it only sends three ELRP PDUs before changing to master
or slave. During this time the column shows No for that VLAN.
Displays the number of ELRP PDUs transmitted.
Displays the number of ELRP PDUs received.
command also
show elrp
ExtremeWare XOS 11.3 Command Reference