Extreme Networks ExtremeWare XOS Command Reference Manual page 1681

Action Displays the configured action the switch takes when ELRP messages are received back
indicating a detection of a network loop or no packets are received within the specified
duration.
The following list describes the actions:
• Print (P)—Specifies that the switch prints a message to the console.
• Log (L)—Specifies that the switch sends a message to the system log file.
• Trap (T)—Specifies that the switch sends a message to the SNMP manager.
• Callback (C)—Specifies a callback action. If you use ELRP with another protocol (for
example ESRP), ELRP uses a callback action to notify the protocol of a loop detection.
Example
The following command displays summary ELRP status information on the switch:
show elrp
The following sample output is displayed:
ELRP Standalone Client:
Number of ELRP sessions:
Number of ELRP pkts transmitted:
Number of ELRP pkts Received:
Client Vlan Ports
--------------------------------------------------------------------------
CLI Default
--------------------------------------------------------------------------
Action : (P) Print , (L) Log , (T) Trap , (C) Callback
History
This command was first available in ExtremeWare XOS 11.1.
Platform Availability
This command is available on all platforms.
ExtremeWare XOS 11.3 Command Reference
Enabled
1
3288
0
Int. Count Cyclic Pkts-Xmit Pkts-Rcvd Action
All 1 0 Yes 3288 0
show elrp
LT
1681