Show Diagnostics - Extreme Networks ExtremeWare XOS Command Reference Manual

show diagnostics

show diagnostics {slot [<slot> | A | B]}
Description
Displays the status of the last diagnostic test run on the switch.
Syntax Description
slot
A | B
Default
N/A.
Usage Guidelines
Use this command to display information from the last diagnostic test run on the switch.
Output on the BlackDiamond 10K Switch. The following switch diagnostic information is displayed:
Slot number
●
Result of the test (pass/fail)
●
Date the test was run
●
Date the test last failed (if the test has never failed,
●
Summary of the test (Diagnostics pass/Diagnostics fail)
●
Output on the BlackDiamond 8800 Family of Switches. The following switch diagnostic information is
displayed:
Date the test last failed (if the test has never failed,
●
Summary of the test (Diagnostics pass/Diagnostics fail)
●
Output on the Summit X450 Switch. The following switch diagnostic information is displayed:
Date the test last failed (if the test has never failed,
●
Summary of the test (Diagnostics pass/Diagnostics fail)
●
Additional Guidelines Applicable to Modular Switches Only. If you use the
command on a slot where diagnostics have not been run, the switch displays a
[<slot> | A | B]}
message similar to the following:
ExtremeWare XOS 11.3 Command Reference
Specifies which I/O module to display diagnostic status information on.
NOTE: This parameter is available only on modular switches.
Specifies which MSM to display diagnostic status information on:
• A specifies the MSM installed in slot A.
• B specifies the MSM installed in slot B.
NOTE: This parameter is available only on modular switches.
Never
Never
Never
is displayed)
is displayed)
is displayed)
show diagnostics {slot
show diagnostics
1677