Configure Debug Coredumps - Extreme Networks ExtremeWare XOS Command Reference Manual

Troubleshooting Commands

configure debug coredumps

configure debug coredumps [internal-memory | memorycard | off]
Description
Enables or disables sending debug information to the specified memory card.
Syntax Description
internal-memory
memorycard
off
Default
By default, the switch does not automatically send debug information to the memory card. The setting
is set to .
off
Usage Guidelines
NOTE
Use this command only under the guidance of Extreme Networks Technical Support personnel to troubleshoot the
switch.
The Summit X450 switch sends debug information to the preinstalled internal memory card. Modular
switches send debug information to the external memory card installed in the external compact flash
slot of the MSM.
The switch only writes core dump files to the specified memory card in the following situations:
If an ExtremeWare XOS process fails.
●
When forced under the guidance of Extreme Networks Technical Support.
●
Modular Switches Only. Before you can enable and save debug information to the external memory card,
you must install an external compact flash memory card into the external compact flash slot of the
MSM. For more information about installing an external compact flash memory card, please refer to the
Extreme Networks Consolidated XOS Hardware Installation Guide.
1654
Specifies that saving debug information to the internal memory card is
enabled.
Use this parameter only under the guidance of Extreme Networks Technical
Support personnel.
NOTE: This parameter is available only on the Summit X450 switch.
Specifies that saving debug information to the external memory card is
enabled.
Use this parameter only under the guidance of Extreme Networks Technical
Support personnel.
NOTE: This parameter is available only on modular switches.
Specifies that saving debug information to the memory card is disabled. This is
the default behavior.
ExtremeWare XOS 11.3 Command Reference