Configure Cna-Testplug Scheduler Ipaddress - Extreme Networks ExtremeWare XOS Command Reference Manual

Version 11.3

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

configure cna-testplug scheduler ipaddress

configure cna-testplug scheduler ipaddress <ip_address>

Configures the IP address of the CNA Server using open SSL; you enter the IP address of the CNA

Usage Guidelines

Use this command to configure the CNA Agent with the IP address of the CNA Server. The CNA

Server requests the timing and type of networking testing, and the CNA Agent runs the tests.

You use the CNA Agent only if you are running the Avaya CNA solution; you must have other pieces of the CNA

(available from Avaya) to run these tests.

You enter the IP address of the CNA server.

This command sets up the encryption key that is subsequently used for all communication between the

CNA Agent and the CNA Server.

You must have previously installed the SSH downloadable software module, which contains SSL, to use the CNA

Agent software.

The following command enters the CNA Server's IP address to 10.6.13.116; the CNA Agent uses this IP

address to communicate with the CNA Server:

configure cna-testplug scheduler ipaddress 10.6.13.116

This command was first available in ExtremeWare XOS 11.2.

ExtremeWare XOS 11.3 Command Reference

Specifies the IP address of the CNA Server that communicates with the CNA

Agent to schedule tests and receive the results.

configure cna-testplug scheduler ipaddress

Extremeware xos 11.3