Extreme Networks ExtremeWare XOS Command Reference Manual page 1642

Version 11.3

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

Configuration and Image Commands

Saving configuration on primary MSM ...... done!

Synchronizing configuration to backup MSM .. done!

After the configuration has been saved and replicated to the backup MSM, synchronization begins.

After the initial reboot, if the backup MSM is not available or does not respond within 120 seconds, the

synchronize operation fails.

command to verify that the backup MSM is in sync with the primary

show switch {detail}

BlackDiamond 8800 Family of Switches Only. On the BlackDiamond 8800 family of switches, the I/O

ports on the backup MSM go down when you synchronize the MSMs. When the primary MSM finishes

replicating its configurations and images to the backup MSM, the I/O ports on the backup MSM come

The following example assumes you have already saved your runtime configuration.

The following command replicates all saved images and configurations from the master MSM to the

After you enter

, status messages similar to the following appear:

Synchronize will reboot the backup MSM, then overwrite all code images

and configs with a copy from the master MSM.

Synchronize currently requires Extremeware XOS version 11 or greater on

the backup MSM

DO NOT interrupt synchronize, the backup MSM may become unbootable!

OK to continue? (y/n) Yes

Rebooting Backup MSM...

NOTE: The command line is locked during synchronize

synchronizing...

synchronizing nvram...

synchronizing XOS...

[========================================] 100% XOS

Synchronize complete - rebooting backup MSM...

BD-10808.4 #

This command was first available in ExtremeWare XOS 11.0.

ExtremeWare XOS 11.3 Command Reference

Extremeware xos 11.3