Activating Or Deactivating Ivr Zone Sets; Verifying Ivr Zone And Ivr Zone Set Configuration - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

IVR Zones and IVR Zone Sets
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Using the force option of IVR zone set activation may cause traffic disruption, even for devices that are
Caution
not involved in IVR. For example, if your configuration does not have any active zone sets and the
default zone policy is permit, then an IVR zone set activation will fail. However, IVR zone set activation
will go through if the force option is used. Because zones are created in the edge VSANs corresponding
to each IVR zone, traffic may be disrupted in edge VSANs where the default zone policy is permit.

Activating or Deactivating IVR Zone Sets

To activate or deactivate an existing IVR zone set, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ivr zoneset activate name IVR_ZoneSet1
switch(config)# ivr zoneset activate name IVR_ZoneSet1 force
switch(config)# no ivr zoneset activate name IVR_ZoneSet1
To replace the active IVR zone set with a new IVR zone set without disrupting traffic, activate the new
Note
IVR zone set without deactivating the current active IVR zone set.

Verifying IVR Zone and IVR Zone Set Configuration

Verify the IVR zone and IVR zone set configurations using the show ivr zone and show ivr zoneset
commands. See
Example 23-6 Displays the IVR Zone Configuration
switch# show ivr zone
zone name sample_vsan2-3
zone name ivr_qa_z_all
Cisco MDS 9000 Family CLI Configuration Guide
23-32
Example 23-6
pwwn 21:00:00:e0:8b:02:ca:4a vsan 3
pwwn 21:00:00:20:37:c8:5c:6b vsan 2
pwwn 21:00:00:e0:8b:06:d9:1d vsan 1
pwwn 21:01:00:e0:8b:2e:80:93 vsan 4
pwwn 10:00:00:00:c9:2d:5a:dd vsan 1
pwwn 10:00:00:00:c9:2d:5a:de vsan 2
pwwn 21:00:00:20:37:5b:ce:af vsan 6
pwwn 21:00:00:20:37:39:6b:dd vsan 6
pwwn 22:00:00:20:37:39:6b:dd vsan 3
pwwn 22:00:00:20:37:5b:ce:af vsan 3
pwwn 50:06:04:82:bc:01:c3:84 vsan 5
to Example 23-14.
Chapter 23 Configuring Inter-VSAN Routing
Purpose
Enters configuration mode.
Activates the newly created
IVR zone set.
Forcefully activates the
specified IVR zone set.
Deactivates the specified IVR
zone set.
OL-18084-01, Cisco MDS NX-OS Release 4.x