Crypto Ca Test Verify - Cisco MDS 9124 - Fabric Switch Reference

Chapter 4 C Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

crypto ca test verify

To verify a certificate file, use the crypto ca test verify command in configuration mode.
Syntax Description
certificate-file
Defaults
None.
Command Modes
Configuration mode.
Command History Release
3.0(1)
Usage Guidelines
The crypto ca test verify command is only a test command. It verifies the specified certificate in PEM
format by using the trusted CAs configured and by consulting the CRL or OCSP if needed, as per the
revocation checking configuration.
Examples
The following example shows how to verify a certificate file. Verify status code 0 means the verification
is successful.
switch(config)# crypto ca test verify bootflash:id1.pem
verify status oode:0
verify error msg:
Related Commands Command
show crypto ca
certificates
OL-16217-01, Cisco MDS SAN-OS Release 3.x
crypto ca test verify certificate-file
Modification
This command was introduced.
Description
Displays configured trust point certificates.
Specifies the certificate filename in the form bootflash:filename. The
maximum size is 512 characters.
Cisco MDS 9000 Family Command Reference
crypto ca test verify
4-127