Activating Ivr Zone Sets; Deactivating Ivr Zone Sets; Recovering An Ivr Full Zone Database - Cisco DS-C9216I-K9 Configuration Manual

Configuring an IVR Topology
To create a zone set, right-click the ZoneSets folder in the Edit Full Database on Switch dialog, and
Step 3
choose Insert.
Enter the zone set name in the dialog box that appears and click OK to add the zone set.
Step 4
The zone set is automatically added to the zone database.

Activating IVR Zone Sets

Once the zone sets have been created and populated, you must activate the zone set.
To activate an IVR zone set, follow these steps:
Right-click the zone set in the Zone > IVR (Inter VSAN Routing) > Edit Full Database on Switch dialog.
Step 1
Click Activate.
Step 2
Note

Deactivating IVR Zone Sets

To activate a zone set, follow these steps:
Right-click the zone set in the Zone > IVR (Inter VSAN Routing) > Edit Full Database on Switch dialog.
Step 1
Click Deactivate.
Step 2

Recovering an IVR Full Zone Database

You can recover an IVR zone database by copying the IVR full zone database.
To recover an IVR zone database, perform these steps.
From the Fabric Manager, choose Zone > IVR (Inter VSAN Routing) > Recover Full Zone Database.
Step 1
You see the Recover Full Zone Database dialog.
Click the Copy Active or the Copy Full radio button, depending on which type of database you want to
Step 2
copy.
Choose the source VSAN from which to copy the information from the drop-down list.
Step 3
If you selected Copy Full, choose the source switch and the destination VSAN from those drop-down
Step 4
lists.
Cisco MDS 9000 Fabric Manager Switch Configuration Guide
16-6
The active zone set in Edit Zone is always shown in bold, even after successful activation. This
is because a member of this VSAN must be participating in IVR zoning. Since the IVR zones
get added to active zones, the active zone set configuration is always different from local zone
set configuration with same name.
Chapter 16 Configuring Inter-VSAN Routing
OL-7753-01