[26-57] Dhcp-Gi-Address; [26-62] Mlppp-Bundle-Name - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

[26-57] DHCP-GI-Address

Use the following command to manage the DHCP-GI-Address RADIUS attribute.
radius include dhcp-gi-address

[26-62] MLPPP-Bundle-Name

Use the following command to manage the MLPPP-Bundle-Name RADIUS attribute.
radius include mlppp-bundle-name
See radius include
Example
host1(config)#radius include dhcp-mac-address acct-stop enable
Use the no version to restore the default, disable.
radius include dhcp-gi-address
Use to include the DHCP-GI-Address attribute in Access-Request, Acct-Start, and
Acct-Stop messages.
You can control inclusion of the attribute by enabling or disabling this command.
See radius include
Example
host1(config)#radius include dhcp-gi-address acct-stop enable
Use the no version to restore the default, disable.
radius include mlppp-bundle-name
Use to include the MLPPP-Bundle-Name attribute in Access-Request, Acct-Start,
Interim-Acct, or Acct-Stop messages.
You can control inclusion of the MLPPP-Bundle-Name attribute by enabling or
disabling this command.
There is no explicit command to include the MLPPP-Bundle-Name attribute in
Interim-Acct messages; however, the attribute is automatically included in
Interim-Acct messages when the attribute is enabled for Acct-Stop messages.
See radius include
Example
host1(config)#radius include mlppp-bundle-name acct-start enable
Use the no version to restore the default, disable.
Chapter 3: Configuring RADIUS Attributes
CLI Commands Used to Modify RADIUS Attributes
229