[67] Tunnel-Server-Endpoint; [68] Acct-Tunnel-Connection; [77] Connect-Info - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

JUNOSe 11.1.x Broadband Access Configuration Guide

[67] Tunnel-Server-Endpoint

Use the following command to manage the Tunnel-Server-Endpoint RADIUS attribute.
radius include tunnel-server-endpoint

[68] Acct-Tunnel-Connection

Use the following command to manage the Acct-Tunnel-Connection RADIUS attribute.
radius include acct-tunnel-connection

[77] Connect-Info

Use the following commands to manage and display information for the Connect-Info
RADIUS attribute.
212
CLI Commands Used to Modify RADIUS Attributes
Example
host1(config)#radius include tunnel-client-endpoint acct-start enable
Use the no version to restore the default, enable.
radius include tunnel-server-endpoint
Use to include the Tunnel-Server-Endpoint attribute in Access-Request, Acct-Start,
and Acct-Stop messages.
You can control inclusion of the Tunnel-Server-Endpoint attribute by enabling
or disabling this command.
See radius include
Example
host1(config)#radius include tunnel-server-endpoint acct-stop disable
Use the no version to restore the default, enable.
radius include acct-tunnel-connection
Use to include the Acct-Tunnel-Connection attribute in Access-Request, Acct-Start,
or Acct-Stop messages.
You can control inclusion of the Acct-Tunnel-Connection attribute by enabling
or disabling this command.
See radius include
Example
host1(config)#radius include acct-tunnel-connection acct-stop enable
Use the no version to restore the default, enable.