Display Protocol-Vlan Interface - 3Com 8807 Command Reference Manual

84 C 4: VLAN C
HAPTER
Protocol-Based VLAN
Configuration
Commands
display protocol-vlan
interface
C
ONFIGURATION OMMANDS
Note that you can add/delete trunk port and hybrid port to/from VLAN by the port
and undo port commands in Ethernet port view, but not in VLAN view.
Related command: display vlan.
Example
# Add Ethernet2/1/1 through Ethernet2/1/3 to VLAN 2.
[3Com-vlan2] port ethernet2/1/1 to ethernet2/1/3
Syntax
display protocol-vlan interface { interface-list | all }
View
Any view
Parameter
interface-list: Displays the protocol information of a specified interface, in the form
of interface-list = { interface-type interface-number [ to interface-type
interface-number ] }. interface-type is interface type, interface-number is interface
number. The interface number after the keyword to must be larger than or equal
to the interface number before to.
all: Displays the protocol information of all ports.
Description
Use the display protocol-vlan interface command to view the protocol
information and protocol index configured on the specific port, to which you can
refer when you use the protocol-based VLAN and add/delete a protocol.
Related command: display interface.
Example
# Display the protocol information and protocol index configured on
Ethernet2/1/1.
<SW8800> display protocol-vlan interface ethernet2/1/1
Interface: Ethernet2/1/1
Vlan-ID
10
10
10
10
10
10
10
10
Index Type
0 at
1 ethernetii
2 llc
3 snap
4 ipx ethernetii
5 ipx llc
6 ipx raw
7 ipx snap
Value
etype 0x0600
dsap 0x01 ssap 0x02
etype 0x0700