Step 12. Program Cab Display Module (Cdm) - MacDon M105 Unloading And Assembly Instructions

STEP 12. PROGRAM CAB
DISPLAY MODULE (CDM)
The monitoring system requires programming
for each header, and the HEADER MUST BE
ATTACHED TO THE WINDROWER.
Programming the system may be accomplished
with or without the engine running.
•
IF ENGINE
transmission must be in NEUTRAL.
•
IF ENGINE IS NOT RUNNING, the
ignition must be ON.
Exit Programming Mode at any time by pressing
PROGRAM switch, or by turning the ignition
OFF.
The system only needs to be programmed once
for each header. The Operator may make
changes later on to a particular setting to suit
windrowing conditions or modifications to the
machine.
Most functions have been pre-programmed at
the factory, but can be changed by the Operator
if required.
SIDE DISPLAY
Displays Software Revision Status
Upper Line - C### (CDM)
Lower Line - M### (WCM)
PROGRAM SWITCH
Places Monitor Into Program Mode
Press While Depressing SELECT Switch.
Press To Exit Program Mode.
* Fast scroll applies only when changing OVERLOAD SPEED (with expansion module), and TIRE SIZE.
169558
UNLOADING AND ASSEMBLY
IS RUNNING, the
MENU ITEM SCROLL BACKWARD
Displays Value Under Menu Item
Push To Scroll Backward.
Keep Depressed For Fast Scroll. *
Proceed as follows to program the CDM:
a. Turn ignition key to RUN, or start the engine.
See STEP 13J. III. START ENGINE on page 43.
b. Press PROGRAM and SELECT on CDM to
enter Programming Mode.
c. Press SELECT.
displayed on upper line.
d. Press and then SELECT.
e. HEADER TYPE? is displayed. DRAPER is
flashing on lower line.
f. Press or
line.
g. Press SELECT.
h. TILT CYL INSTALLED? is displayed.
i. Press or
line.
j. Press SELECT to advance to the next L1 item
and press arrow keys to change values.
k. Press PROGRAM to exit Programming Mode
when finished entering desired values.
Refer to Detailed Programming Instructions on
following pages.
Contact
information
updates to the electronic modules.
Displays Value Under Menu Item
Push To Scroll Forward.
Keep Depressed For Fast Scroll. *
33
TRACTOR SETUP?
to change value on lower
to change value on lower
NOTE
the manufacturer
regarding software
MAIN DISPLAY
Displays Menu Item and Selection
Upper Line - Menu Item
Lower Line - Selection
SELECT SWITCH
Places Monitor Into Program
Mode With PROGRAM Switch
Press to Accept Menu Item and
Advance to Next Item.
MENU ITEM SCROLL FORWARD
Revision D
is
for