Checking Gauges And Cab Display Module (Cdm) Display; Checking Electrical System - MacDon M155 Unloading And Assembly Instructions

5.11.4 Checking Gauges and Cab Display Module (CDM) Display

1. Ensure the engine temperature gauge (A) and fuel
gauge (B) are working.
2. Ensure the CDM display (A) is working by pushing the
SELECT (B) button on the CDM or the SELECT (C)
button on the ground speed lever (GSL).

5.11.5 Checking Electrical System

1. Push the SELECT button (C) on the ground speed lever
(GSL) or the SELECT button (B) on the cab display
module (CDM) until the CDM display (A) shows VOLTS.
The display indicates the condition of the battery and
alternator. Refer to Table
214298
PERFORMING PREDELIVERY CHECKS
5.4, page 231.
Figure 5.19: Temperature and Fuel Gauges
Figure 5.20: CDM
Figure 5.21: Cab Display Module (CDM)
230
Revision A