Step 29. Program Cab Display Module (Cdm) - MacDon M 2009 Series Assembly Instructions Manual

STEP 29. PROGRAM CAB
DISPLAY MODULE
(CDM)
The monitoring system requires programming for
each header, and the header must be attached to
the windrower.
Programming the system may be acco mplished
with, or without the engine running. If the engine
is running, the transmission must be in NEUTRAL.
If the engine is not running, the ignition must be
ON.
Exit programming mode at any time by pressin g
the PROGRAM switch, or by turning OFF ignition.
The system only needs to be pro grammed once
for each header. T he Operator may make
changes later on to a particular setting to suit
windrowing conditions or modifications to the
machine. Most functio
programmed at the factory, but can be changed by
the Operator if required.
The following functions can be pro grammed by the
Dealer, provided the applicable information from
the Operator has been provided, and the heade r is
installed:

DWA INSTALLED (M155, M205 ONLY)

HDR CUT WIDTH

HAY CONDITIONER INSTALLED

CALIBRATE SENSORS
SIDE DISPLAY
Displays Software Revision Status
Upper Line: C### (CDM)
Lower Line: M### (WCM) for
M155/M105 OR X### for M205.
PROGRAM SWITCH
Places Monitor into Program Mode
Press While Depressing SELECT Switch
Press to Exit Program Mode.
Form 169542
UNLOADING AND ASSEMBLY
ns have be en pre-
MENU ITEM SCROLL
BACKWARD
Displays Value under Menu Item
Push To Scroll Backward.
* Fast scroll applies only when changing
KNIFE SPEED, OVERLOAD PRESSURE, and TIRE SIZE.
Proceed to program the CDM as follows:
Header must be attach ed to the
windrower so that the CDM can detect
the type of h eader (Header ID), an d
adjust
accordingly.
a. Turn ignition key to RUN, or start the engine.
Refer to STEP 21. START ENGINE.
b. Press PROGRAM and SELECT
together on CDM to enter programming mode.
Header ID code is displayed.
c. Press SELECT.
displayed.
d. Press . SET KNIFE SPEED? is displayed.
e. Press SELECT until DWA INSTALLED? is
displayed.
f. Press or
g. Press SELECT to advance to the next L1 item.
h. Press PROGRAM to exit programming mode.
i. Refer to the following pages depending on your
machine. The functions requiring programming
are highlighted with
Programming Instructions:
A. M205, M155 Detailed Programming
Instructions, or
B. M105 Detailed Programming Instructions.
88
IMPORTANT
the prog ramming mode
TRA CTOR SETUP? is
.
MAIN DISPLAY
Displays Menu Item and Selection
Upper Line: Menu Item
Lower Line: Selection
SELECT SWITCH
Places Monitor into Program
Mode with PROGRAM Switch
Press to Accept Menu Item and
Advance to Next Item.
MENU ITEM SCROLL FORWARD
Displays Value under Menu Item
Push To Scroll Forward.
Keep Depressed For Fast Scroll. *
switches
in th e
Revision F