Cab Panel Removal - jcb JS300 Service Manual

The cab is fitted with five plastic trim panels. The panels
are fixed to the cab frame with screws.
Components, such as electrical switches, locate in some
of the cab panels. During removal and replacement be
sure to disconnect and reconnect the applicable harness
connectors.
Do not force the panels away from the cab frame, be sure
to remove all the fixings.
If a cab panel is replaced with a new one transfer the
applicable components to the new panel.
The table lists the cab panels and their fixings:
1 RH 'C' Post Panel.
1A Fixings - 4 x screws and nylon washers
1B Emergency hammer
Remove the emergency hammer 1B to get access to the
fixings.
Remove the centre console panel 3 to get access to the
fixings
K Fig 16. ( T B-44)
2 Rear Panel.
2A Fixings - 7 x screws and nylon washers
Disconnect / connect the ventilation hoses at the rear of
the panel
3 Centre Console Panel.
3A Fixings - 8 x screws and nylon washers
3B Fixing - 1 x bolt and nylon washer
3C Stowage plate
3D Cover
Remove the rear panel 2 to get access to the fixings
Remove the cover 3D to get access to the fixing
Remove / replace the stowage plate 3C
K Fig 16. ( T B-44)
4 'A' Post Panel.
4A Fixings - 2 x screws and nylon washers
4B Fixings - 2 x bolts and nylon washers
Remove / replace the stowage plate 3C
Remove / replace the DECU ECU. Refer to Section C.
B-43

Cab Panel Removal

K Fig 16. ( T B-44)
K Fig 16. ( T B-44)
Section B - Body and Framework
5 LH 'C' Post Cover.
5A Fixings - 4 x screws and nylon washers
5B Coat hook
5C Fixings - 2 x screws and nylon washers
Remove the rear panel 2 to get access to the fixings
Remove / replace the coat hook 5B
9813/5100-1
Cab
Cab Panel Removal
K Fig 17. ( T B-45)
B-43