Suction Strainer - jcb JS300 Service Manual

Clean / Replace
1 Prepare the machine.
Maintenance, Maintenance Positions.
2 Release the tank pressure. Refer to Section 2,
Maintenance, Hydraulic System.
3 Get access to the suction strainer.
Points ( T E-296)
C
Fig 8.
4 Remove the suction strainer as follows:
a Remove the filler port cover A and O-ring B.
b Remove the suction strainer C from inside the
hydraulic tank.
E-303

Suction Strainer

Refer to Section 2,
K Service
A
B
9813/5100-1
Section E - Hydraulics
Routine Maintenance Procedures
5 At the applicable service interval clean the suction
strainer using a suitable cleaning fluid. Refer to
Section 2, Maintenance, Maintenance Schedules.
Make sure that
contamination. If the strainer is defective replace it
with a new one.
6 At the applicable service interval replace the suction
strainer with a new one. Refer to Section 2,
Maintenance, Maintenance Schedules.
7 Installation of the suction strainer is a reversal of
removal. Fit a new O-ring seal to the filler port cover
A and secure the fasteners.
Suction Strainer
the strainer is free
E-303
from