jcb JS300 Service Manual page 163

Deferring Regeneration
If you are about to enter a hazard atmosphere (entering into an enclosed environment for example), it may be
necessary to defer auto regeneration mode.
To defer the auto regeneration mode, press the regeneration switch within 5s of the green regeneration symbol
being displayed. The operator may also cancel the auto regeneration by cycling the ignition key or by operating
the engine stop switch.
If the regeneration is suspended the system will automatically re-initiate the auto regeneration after a pre-
set time. If auto regeneration is continuously suspended the engine controller will then request a manual
regeneration.
Manual Regeneration
The machine cannot be operated during this form of regeneration.
If an auto regeneration is continuously cancelled then a manual regeneration will be required. The amber
regeneration symbol will display for 10s, after this time a flashing amber regeneration symbol will display at
the bottom of the screen.
88
Figure 108.
Figure 109.
Figure 110.
9831/1100-2
Operation
Instruments
88