jcb JS300 Service Manual page 244

Unpacking the Guards
Make the machine safe.
Arm Lowered) (Page 184).
Unlock the cage and remove the guards. Leave the guards 2, 3 and 4 in the cage, they are installed from the
top of the machine.
Installing the Guards
It is recommended that a hard hat is worn during the installation procedure and that any part of the machine
that you may need to climb on is clean. Access steps may be required to safely fit some of the guards.
The guards are individually numbered to aid storage, install each numbered guard in the position shown.
A
7
B
1
6
A Front top panel
B Front bottom panel
C Door front panel
D Door rear panel
E
Boom side panel
F
Boom side panel
G Rear window panel
169
Refer to: Maintenance > Maintenance Positions > Maintenance Position (Excavator
C
D
5
Figure 202.
G
2
9831/1100-2
Preservation and Storage
Security
F
4
E
3
169